Getting Started / Maintenance / Troubleshooting - Seliger AQUASPOT 300 POWER LED Mode D'emploi

GETTING STARTED
PUTTING THE AQUASPOT INTO OPERATION
Before putting into operation, a few important preparations must be made.
• When you have decided where to use the Aquaspot 300 Power LED, decide for mounting either with a
ground stand or with a peg.
• As the Aquaspot 300 Power LED warms up very much during operation, no inflammable objects and
plants may be placed near the Aquaspot 300 Power LED.
• If not yet existing, prepare an adequate power connection by observing the indications
stated on the transformer and in the operating instructions.
General rule:
• Risk of burns! Before touching the Aquaspot 300 Power LED, switch it off and wait until it has cooled down.
• Please observe the points stated in the chapter Security Indications.
MOUNTING THE AQUASPOT
Ill.2
The delivery extent allows very flexible mounting of the Aquaspot 300 Power LED in two ways: with a peg or
with a ground stand. First examine how firm your ground is. If the ground is very hard or too loose, better use
the ground stand. The peg (ill. 3) is recommended for mounting in gardens, between bushes or stones when you
want to change the Aquaspot 300 Power LED location now and then.
ENGLISH 15