Assembly - Arctic Cove MAC1410K Manuel D'utilisation

UNPACKING
This product requires assembly:
 Carefully remove the product and any accessories from
the box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to
the product by the manufacturer and require customer
installation. Use of a product that may have been improperly
assembled could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
 If any parts are damaged or missing, please call
1-877-297-8911 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
ASSEMBLING THE MISTING KIT
See Figures 1 - 2.
To ensure the product functions properly, always flush and
test the system for leaks before use.
 With the hose faucet turned completely off, attach a
garden hose (not provided) to the misting tube coupler
and hand tighten.
NOTE: The misting tube coupler has been shipped with
an o-ring inside it. Ensure the o-ring has remained in the
coupler.

ASSEMBLY

 Turn faucet on and allow water to run through the garden
hose and misting tube for 30 seconds to wash away any
debris. Then turn faucet off.
 Install brass nozzles into the threaded holes on the misting
tube.
 Turn faucet on fully and allow water to run through the
garden hose and misting tube to pressurize the unit.
NOTE: Make sure the faucet is turned on fully and that
there are no kinks or leaks in the hose.
 Check each threaded hole on the misting tube for leaks.
If leaks are present, refer to the Troubleshooting section
later in the manual.
 If no leaks are present, the misting kit is ready for use.
MOUNTING THE MISTING KIT
See Figures 3 - 7.
WARNING:
Install alligator clamps in an area where no electrical
wires, utility cables, pipes, or other obstructions are
located. Never connect alligator clips to electrical wires
or cords. Contact your local utility company or a qualified
electrician if you are unsure. Ensure alligator clamps
and misting tube are securely installed to prevent falling
object or slippery surface hazard. Failure to follow these
instructions can result in electrical shock or other serious
personal injury.
NOTICE:
This misting kit is designed to be attached to fabric
surfaces, such as umbrellas or fabric awnings, using the
included alligator clips. To attach the misting kit to other
surfaces, an accessory hanging mount kit must be used.
To obtain the best spray area (mist curtain), we recommend
that the misting tube be secured to an overhead support.
Always mount the misting kit in a suitable location away from
electrical devices and switches.
To mount the misting kit:
 Turn the hose faucet completely off and disconnect the
misting tube from the garden hose.
 Use the plastic straps on the alligator clamps to secure
the misting tube to the clamps.
 Squeeze the ends of the clamp to open the clamp mouth
and install the misting kit in a suitable location.
 Reinstall the misting tube to the garden hose and ensure
the o-ring has remained in the coupler.
4 — English