Overview; Operation; Preparation; After Using The Appliance - Siemens MS7 Série Mode D'emploi

Overview

Please fold out the illustrated pages.
X Fig. A
1 Rotary knob and stop plate
Set slicing width (0 to 15 mm).
2 Switch-on safety device
Press and hold to switch on. Prevents
the appliance from being unintentionally
switched on.
3 ON button
Fast and continuous operation
4 Blade
5 Carriage
Guide the food which is to be sliced
against the blade.
6 Slide
Pos. 1 (slide on left)
= Lock the carriage in the end position
Pos. 2 (slide on right)
= Carriage movable
7 Base
Supports the carriage.
8 "Sausage end" holder
Cuts residual pieces safely.
9 Cord bag
For cord storage

Operation

Before using the appliance for the first time,
clean thoroughly.

Preparation

W Risk of electric shock!
Do not use the appliance near a sink filled
with water!
X Fig. A
■ Place the appliance on a smooth, clean
surface.
■ Attach carriage 5 and "sausage end"
holder 8.
■ Use the rotary knob 1 to set the required
cutting width (0 to 15 mm).
In the lower adjustment range a very
narrow slicing width can be set (e.g. for
salami, ham).
■ Insert the plug.
MS_7xxxx_8001027219.indb 9
Switching the appliance ON / OFF
W Risk of injury from sharp blade!
Blade is very sharp. Keep hands clear of
the blade. After switching off, the drive
continues for a short time. After work, set
cutting width to 0.
X Fig. A
Instantaneous switching
■ 1. Press the switch-on safety device and
hold down.
2. Then press ON button until the power
tool starts running.
3. Release the switch-on safety device
again.
■ To stop the appliance, release the ON
button.
Continuous operation
■ 1. Press the switch-on safety device and
hold down.
2. Then press ON button until it locks
into position.
3. Release the switch-on safety device
again.
■ To stop the appliance, press the ON
button again and release.
Slicing
X Fig. A
■ Place the food which is to be sliced on
the carriage and gently push against the
stop plate.
■ Slowly slide the food which is to be
sliced against the moving blade.

After using the appliance

■ Set the slicing width to 0.
■ Slide the carriage towards the blade into
the end position and lock with the slide
6 in Pos. 1.
Notes:
■ Cut sausage and cheese first and bread
last. The appliance is then easier to
clean.
■ For reasons of hygiene, the appliance
and the blade should be cleaned imme-
diately after slicing greasy food (e.g.
meat, sausage, cheese). X "Cleaning"
Overview en
9
09.11.2015 14:00:01