Operation - Visiosat VISIO DATA Mode D'emploi

Operation

All parameters are set with the rotary push button.
Each function and parameters are shown on 2 digits display and different LEDs .
Programming
Enter programming mode
- Make all the necessary connections and connect amplifier to mains.
- Push on the rotary button for more than 3 seconds to enter into programming mode.
ATTENTION !
When security code is activated (see "Exit programming mode" on page 22) :
- Turn the button to display "50"
- Push the button to confirm the code.
Note: the security code "50" is fixed and can not be changed.
The software version is displayed,
followed by a dot.
3 sec.
is displayed.
21