Vivobike M-VCITY26B Mode D'emploi Et D'entretien page 35

1. Tyres & tubes
2. Rims
3. Spokes
4. Front hub with quick release
5. Front fork
6. Front brakes V-brake
7. Front mudguard
8. Handlebar & stem
9. Bell
10. Frame
Instruction
THE "EXTRAORDINARY" MAINTENANCE OF THE MECHANICAL AND ELECTRICAL COMPONENTS MUST BE
PERFORMED BY A QUALIFIED TECHNICIAN.
Ⅲ. MANUAL FOR THE ELECTRIC PARTS OF E-bike mod. 4000RM 26" LS
The rider must pedal forward to obtain any assistance from the motor. This is an important safety feature. This
electric pedal assistance bikes will provide assistance up to 25 Km/h, after that the motor will cut out. You may go
faster but must do so under your own effort without the electric assistance.
To start the bike, turn on the main switch on the side of the battery, the LED on the handlebar panel will light up.
The motor will not work until you pedal one/two full revolutions of the chain wheel. This feature protects the
motor and controller from damage and extends the service life of the electric components.
Contents
1. Structure of an electric assistance bike
2. Important safety cautions
3. Operation
4. Battery installation & usage
5. LED and function
6. Using and maintaining the battery
7. Using and maintaining the charger
8. Using and maintaining the electric hub motor
9. Maintaining the controller
10. Maintaining the "Power-off Control" of the brake lever
11. Simple trouble shooting
12. Electric circuit diagram and specifications
13. Main technical specification sheet
11. Pedals
12. Crank set
13. Carter
14. Seat clamp
15. Seat post
16. Saddle
17. Chain
18. Derailleur protection
19. Rear derailleur
20. Rear hub motor
21. Free wheel
22. Stand
23. Rear mudguard
24. Rear carrier
25. Battery
26. Grip, shift & brake levers
27. Brake cables, brake connections
28. Display
29. Battery charge socket
30. Padlock and key
35/75