Operation - Bartscher Deli-Cool II D Mode D'emploi

Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid specification should
be compared with that of the device (see rating plate). Connect the device only
in case of compliance!
Connect the device only to properly installed single socket with
protective terminal.
Do not disconnect the supply cable by pulling it, always pull the plug.
•
Before use position the device and leave it for at least 2 hours before connecting to the
power supply.
•
After a power outage or after removing the plug from its socket do not connect
the device to a power source for at least 5 minutes.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Position the device in such way that the plug is easily accessible for quick
disconnecting when required.

5.2 Operation

Preparation
•
Before operation become familiar with the device and its equipment by reading
this manual.
•
Before the device operation clean it according to the instructions in section
6.2 "Cleaning".
•
Place the shelves at required height. The possibility of adjusting shelves allows for
placing objects of various height in the refrigerated showcase. The brackets for shelves
are installed in the factory. Position the shelves on the brackets on appropriate level.
•
First connect the supplied cable to the socket on the back side of the device, then
connect the plug to the single grounded socket.
•
The optimal settings are selected in the factory and are in range between 2 ° C
(lower adjustment limit) and 6 ° C (upper adjustment limit). Those settings
correspond to the operational temperature in the refrigerated showcase in range
of approx. 2 ° C – 12 ° C.
- 30 -