Technical Characteristics - TIPTEL DECT Set 50 Mode D'emploi

Technical characteristics

Line interface:
dialling:
CLIP:
Frequency:
Extensions per base station:
Data rate:
Range:
Power supply:
Power consumption:
Telephone cable:
Dimensions (WxHxD):
Weight:
Ambient temperature:
Registration procedure for a DECT GAP handset
Make sure both base unit and extension unit are powered on and an extension
unit is registered. You may register up to 4 extension units/handsets.
After powercycling the base unit twice the LED is fast green blinking and open for
registration of a handset. Repeat the procedure after one minute in case it does
not start blinking fast.
The GAP handset can be registered using the handset registration procedure, PIN
(AC) code is "1234" for the base unit.
After successful registration the base unit stops blinking and you can use the
handset in parallel with the extension unit. To make a global call to all parallel
devices use the key "internal" first followed by any number. Dial "#" with analogue
devices connected to an extension unit followed by any number. It is not possible
to call specific devices.
English
according TBR37 and TBR38
DTMF
FSK
1,8 GHz DECT
Up to 4
V.90/V.92 and V.34 modem up to 56Kbit/s
(minimum of 28.8Kbit/s)
300 m (outside), 50 m (inside)
230V +/- 10%, integrated
<1.0W (idle), <2.0W (active)
Length 1.5 m
95 x 60 x 75 mm
<100 g
10°– 40°C, for indoor use only
15