Uline H-813 Mode D'emploi

H-813
SIDE LOADER
TAPE DISPENSER
WIPE DOWN BLADE
ROLLER
BLADE
ADHESIVE SIDE
OF TAPE DOWN
METAL LOADING GATE
1. Place dispenser on flat surface. Push tape roll fully onto
dispenser. Be sure tape unwinds with sticky side down.
(See Figure 1)
2. Unroll 5-6 inches of tape (sticky side down) and thread
between roller and metal loading gate. (See Figure 2)
3. Pull tape over roller allowing tape to unroll freely.
(See Figure 3) To adjust tension, see Figure 4.
Figure 1
A
PAGE 1 OF 3
1-800-295-5510
uline.com
REFERENCE
ADJUSTABLE
TENSION KNOB
OPERATION
Figure 2
B
TO RELEASE CORE ADAPTER – Pull up on tab to release
4. Start desired depth on the side of the box.
(See Figure 5, A)
5. Roll dispenser along the carton seam. Tape should
be applied evenly and smoothly with pressure being
applied by the roller. (See Figure 5, B)
6. Continue down the opposite end to desired length. Tilt
dispenser forward, allowing the blade to cut the tape
and the wipe down blade to seal down the end of the
tape. (See Figure 5, C)
Figure 3
Para Español, vea página 2.
Pour le français, consulter les page 3.
outer core and pull out to
change from a 3" core to
a 1⁄" core.
Figure 4
Figure 5
C
0421 IH-813