Getac X500 Serie Manuel De Fonctionnement page 8

•
Ensure the batteries are installed correctly
according to polarity (+ and -).
•
Do not mix old and new batteries, different
brands or types of batteries, such as alkaline,
carbon-zinc, or rechargeable batteries.
•
Remove and immediately recycle or dispose
of batteries from equipment not used for an
extended period of time according to local
regulations.
•
Always completely secure the battery com-
partment. If the battery compartment does
not close securely, stop using the product,
remove the batteries, and keep them away
from children.
About the AC Adapter
•
Use only the AC adapter supplied with your
computer. Use of another type of AC adapter
will result in malfunction and/or danger.
•
If a ground/earth pin attachment plug on
the AC power cord is provided, always plug
the cord into a grounded/earthed outlet. Do
not disable ground/earth pin of the
plug/cord.
•
Do not use the adapter in a high moisture
environment. Never touch the adapter when
your hands or feet are wet.
•
Allow adequate ventilation around the adapter
when using it to operate the device or charge
the battery. Do not cover the AC adapter with
paper or other objects that will reduce cooling.
Do not use the AC adapter while it is inside a
carrying case.
•
Connect the adapter to a proper power
source. The voltage requirements are found
on the product case and/or packaging.
•
Do not use the adapter if the cord becomes
damaged.
•
Do not attempt to service the unit. There are
no serviceable parts inside. Replace the unit
if it is damaged or exposed to excess
moisture.
Heat Related Concerns
Your device may become very warm during
normal use. It complies with the user-accessible
surface temperature limits defined by the Inter-
national Standards for Safety. Still, sustained
contact with warm surfaces for long periods of
time may cause discomfort or injury. To reduce
potential heat-related concerns, follow these
guidelines:
•
Keep your device and its AC adapter in a well-
ventilated area when in use or charging.
Allow for adequate air circulation under and
around the device.
6
•
Use common sense to avoid situations where
your skin is in contact with your device or its
AC adapter when it's operating or connected
to a power source. For example, don't sleep
with your device or its AC adapter, or place
it under a blanket or pillow, and avoid con-
tact between your body and your device when
the AC adapter is connected to a power
source. Take special care if you have a phys-
ical condition that affects your ability to
detect heat against the body.
•
If your device is used for long periods, its
surface can become very warm. While the
temperature may not feel hot to the touch,
if you maintain physical contact with the
device for a long time, for example if you
rest the device on your lap, your skin might
suffer a low-heat injury.
•
If your device is on your lap and gets uncom-
fortably warm, remove it from your lap and
place it on a stable work surface.
•
Never place your device or AC adapter on
furniture or any other surface that might be
marred by exposure to heat since the base
of your device and the surface of the AC
adapter may increase in temperature during
normal use.
Regulatory Information
USA
Federal Communications Commission
Radio Frequency Interference Statement
NOTE:
This equipment has been tested and found to
comply with the limits for a Class B digital device
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not
installed and used in accordance with the instruct-
tions, may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the equip-
ment off and on, the user is encouraged to try
to correct the interference by one or more of
the following measures:
•
Reorient or relocate the receiving antenna.