Know Your Product; Description, Specifications And Instructions - Rona 2001599 Manuel D'utilisation

KNOW YOUR PRODUCT

5 7
6
Parts list
1. On/off trigger switch
2. Lock-on button
3. Soft grip handle
E
4. Forward/reverse lever switch
5. Keyless chuck
6. Auxiliary handle
7. Depth gauge
8. Hammer action selector
12
8
4
2
3
1
DESCRIPTION, SPECIFICATIONS AND
INSTRUCTIONS
Description of symbols
The rating plate on your tool may show
symbols. These represent important
information about the product or instructions
on its use.
Wear hearing protection.
Wear eye protection.
Wear breathing protection.
Double insulated for
additional protection.
Portable Electric Tools UL745-1:
First Ed, Rev November 4, 2004,
CAN/CSA-C22.2 No. 745-1:
3087208 First Ed, Rev November 4, 2004,
Particular Requirements for Drills
UL 745-2-1:
First Ed, Rev February 19, 1997,
CAN/CSA-C22.2 No. 745-2-1:
First Ed, Rev February 19, 1997
Environmental protection
Recycle unwanted materials
instead of disposing of them
as waste. All tools, hoses and
packaging should be sorted, taken
to the local recycling centre and disposed of
in an environmentally safe way.
Specifications
Voltage: 120V ~ 60 Hz
Power rating: 6 AMP
No load speed: 0–2,700 RPM
(forward and reverse)
Chuck capacity: 1/2" (2-13 mm) dia
No. of impacts: 43,200 BPM
Drilling capacity: Steel 3/8" (10 mm)
Aluminium 1/2" (13 mm)
Wood 9 13/16" (25 mm)
Weight: 4.4 lbs (2 kg)
This tool is double insulated. There are two
independent barriers of insulation to protect
you from the possibility of electric shock.
General safety instructions
WARNING! Read and understand all
instructions. Failure to follow all instructions
listed below, may result in electric shock, fire
and/or serious personal injury.
Save these instructions.
Work area
• Keep your work area clean and well lit.
Cluttered benches and dark areas invite
accidents.
• Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases, or dust. Power
tools create sparks which may ignite the
dust or fumes.
• Keep bystanders, children, and visitors
away while operating a power tool.
Distractions can cause you to lose control.
Electrical safety
• Double insulated tools are equipped with
a polarized plug (one blade is wider than
the other.) This plug will fit in a polarized
outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to
install a polarized outlet. Do not change the
plug in any way. Double insulation eliminates
the need for the three wire grounded power
cord and grounded power supply system.
• Avoid body contact with grounded
surfaces such as pipes, radiators, ranges
and refrigerators. There is an increased risk
of electric shock if your body is grounded.
• Do not expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock.
• Handle the cord carefully. Never use the
cord to carry the tool or to pull the plug from
an outlet. Keep the cord away from heat,
oil, sharp edges or moving parts. Replace
damaged cords immediately. Damaged
cords increase the risk of electric shock.
• When operating a power tool outside, use
an outdoor extension cord marked "W-A"
or "W". These cords are rated for outdoor
use and reduce the risk of electric shock.
13
E