Abus Secvest Instructions D'installation Et D'utilisation page 31

Step 6: Switch on sounder
Caution
The sounder should not be activated in the following steps. You should, however, be prepared for
the fact that the sounder might nevertheless be activated. Make sure that any loud sounds emitted
do not startle you, causing you to fall off the ladder.
 Connect the batteries.
The sounder should switch on in "silent start mode", which is indicated by the fact that the
comfort LEDs are permanently on.
Important
Insert the battery cables in the guides provided. Otherwise, the cables may be crushed.
 Put the jumper/connector cover back on, close the lid, tighten the cover fixing screws and
close the screws' covers.
Ten seconds after closing the lid, the comfort LEDS will flash alternately to indicate that the
sounder is ready. (If you open the lid again, the sounder will activate itself.)
 Test the system fully.
 Exit installer mode on the alarm panel. The system is now ready.
Installation
31 | EN