Recording Bias Adjustment; Rec/Rec Mute And Rec Pause Button; Dimmer Adjustment - Denon DRM-555 Mode D'emploi

2

RECORDING BIAS ADJUSTMENT

For best recording results, monitoring during recording and comparing
different recordings using your own judgement are essential.
The DENON cassette deck is equipped with a Bias Fine control (BIAS FINE)
to assist you in setting the proper bias for different types and brands of
tape. At the center stop-click position, the deck is set to the reference bias
level for Normal, CrO and Metal tape. If the resulting recording in this
2
position has too much or too little high frequency content, adjusting the Bias
Fine control (BIAS FINE) can be useful to achieve better results.
-
If the high frequencies (treble sounds) are to be boosted, turn the Bias Fine
control (BIAS FINE) counter-clockwise to decrease the bias current. Turn the
control clockwise to increase bias current.
By the use of this control, you can record tapes with a frequency response
that will perfectly match your listening taste.
FREQUENCY (Hz)

DIMMER ADJUSTMENT

With the DRM-555, the brightness of the display can be adjusted in seven steps.
To make the display brighter, press the Fast Forward button (
To make the display dimmer, press the Fast Rewind button (
The display is initially set to the maximum brightness.
BIAS FINE
+
Counterclockwise
Clockwise
7
) while holding in the Stop button (
6
) while holding in the Stop button (
2

REC/REC MUTE AND REC PAUSE BUTTON

1. To record a 5-second blank section during recording:
Press the Rec/Rec Mute button (REC/REC MUTE) (
will be recorded and the deck will enter the recording standby mode.
2. To record a 5-second blank section during the recording standby mode:
Press the Rec/Rec Mute button (REC/REC MUTE) (
standby mode. A 5 second blank will be recorded and the deck will enter the
recording standby mode again.
3. To cancel recording of blank space:
3
Press the Rec Pause button ( REC PAUSE). Blank space recording will be
cancelled and the deck enters the recording standby mode.
4. To extend the blank section with another 5 seconds or more:
Simply press the Rec/Rec Mute button (REC/REC MUTE) (
section will be increased with another 5 seconds.
2
STOP).
2
STOP).
ENGLISH
4
). A 5-second blank
4
) from the recording
4
) and the blank
11