Install Nature Spa - Zodiac Pool Systems Nature2 Guide Du Propriétaire

Install Nature
2
Nature Spa is designed to fit most portable spas. Zodiac
assumes no liabilities for the product if installed in any way
other than the methods described in this manual.
1. Balance the water per spa manufacturer guidelines.
2. Install Nature
Assembly and Installation Diagrams below for instructions
regarding your particular model's installation.
3. Superoxidize the spa water with a Health Canada approved
source of sodium dichlor
instructions to burn off contaminants and activate Nature
Spa. Important: Initial superoxidation with sodium
dichlor is required to burn off contaminants and
activate Nature
• Add 1.5 tablespoons of sodium dichlor to spa
per 1000 litres (approx. 250 gallons).
• Do not enter the spa if the free available chlorine
residual is over 5 ppm.
4. Run spa according to recommendations supplied to you
by the manufacturer of your spa.
Assembly and Installation Diagrams
2
Nature Spa comes in three (3) parts; the main body (A) and
two support stems (B, and C).
1. Connect the support stems together and press onto main
body to create a single device as shown.
A
Sodium dichloroisocyanurate dihydrate
2
2®
2
Spa after the water is balanced. Refer to
2
2
Spa.
Spa
according to the manufacturer's
B
C
4
A
B
C
2