EasyWalker SKY Mode D'emploi page 6

Release the button and check whether the wheel is secured by pulling it. Repeat
this process on the opposite side with the other rear wheel (image 6).
To remove the rear wheel, press the button in the middle of the rear wheel while
pulling the wheel off the frame.
IMPORTANT: The rear wheels cannot be fitted to the frame if the parking brake of the
EasyWalker SKY is engaged.
The front wheel is mounted, as standard, on the front fork. You can secure this by fully
sliding out the black sliding button of the swivelling wheel underneath the footplate and
then positioning the fork in the opening intended for this (image 7). Now release the
sliding button and press this in properly. Check that the fork is properly secured (image
8).
To remove the front fork and wheel, slide the black sliding button (underneath the
footplate) out completely while pulling the front fork out of its mounting (image 9).
Inflate the tires of your EasyWalker SKY with a pump used for car tires. The maximum
pressure for the tires is 1.4 Bar (20 psi) (im age 10).
TIP: You can buy a tapering converter at a bike shop so that you can use a bicycle pump
to inflate the EasyWalker SKY's tires.
IMPORTANT: The maximum pressure for the tyres is 1.4 Bar (20 psi).
IMPORTANT: Ensure that all of the EasyWalker SKY's tyres are inflated equally. Unequal
tyre pressure can lead to instability of the EasyWalker SKY and can impact upon the
safety and comfort of your children.
IMPORTANT: If the tyres have been over-inflated, they may explode in hot weather. Make
sure you consider raised temperatures in the boot of your car or in a conservatory, for
example.
IMPORTANT: There may be grease on the axle; be careful with clothing and never let
children play with the wheels.
IMPORTANT: Do not leave the caps from the valves lying around. Prevent children putting
them in their mouths.
Seat
WARNING: Always use the 5­point harness when your child is carried in the seat.
!
WARNING: The seat is not suitable for children under 6 months.
!
The EasyWalker SKY is supplied with the seat and the storage basket already fitted.
To remove the seat, open the Velcro fastenings behind the footplate. Then open the
poppers on the fabric tapes, left and right on the back of the seat. Now open all other
poppers and Velcro fastenings on both sides of the seat (image 11).
To put the seat back onto the frame close the poppers and Velcro fastenings on both
sides of the seat. Close the Velcro fastenings behind the footplate. Finally, close the
poppers on the tapes at the back of the seat around the frame tubes, just above the rear
suspension. These tapes are part of the harness and provide extra comfort and security
for your child.
!
WARNING: Check that the seat and the carrycot are properly attached to the supporting
frame and that they are securely fixed, before you use the EasyWalker SKY.
EN­17