Goobay 58976 Mode D'emploi page 18

User manual
Fig. 7: Selection input source via selection button
b) Selection via remote control
Fig. 8: Selection via arrow keys
17
The selection of the input signal and it´s source device 1 - 4
takes place in a cyclic order:
Input A
Input B
- Remove the plastic strip from the battery compartment of
the remote control before using it for the first time.
For outputs A and B there are separated selection buttons
available for source devices 1-4.
A:
- Press the button 1,2,3 or 4 to switch the source device to
the HDMI output.
The LED will indicate the corresponding input source.
By pressing the arrow keys ◄ ► you can switch between the
input sources 1 / 2 / 3 / 4 in a cyclic order.
B:
- Press the button 1,2,3 or 4 to switch the source device to
the HDMI output.
The LED will indicate the corresponding input source.
By pressing the arrow keys ◄ ► you can switch between the
input sources 1 / 2 / 3 / 4 in a cyclic order:
:
:
- Disconnect the product from the mains when not in use.