Adjusting Tool Rest; Adjusting Tailstock; Installing Bed Extension - Jet JWL-2442-M Mode D'emploi

Push in the spindle lock and use the provided open
spanner (F, Fig 32).
Caution:
If reversing spindle rotation, always make sure face plate,
chuck or vacuum chuck is secured with the set screws.

7.5 Adjusting tool rest

Position the tool rest as close to the workpiece as
possible. Tighten handle (C, Fig 33) to lock.
Set the height to approximately 3mm above centre line.
Tighten indexable knob (D).
If tool rest post begins to slip, tighten up the hex socket
cap screw (E).

7.6 Adjusting tailstock

Turn the hand wheel (P, Fig 34) clockwise to move
tailstock spindle forward. Lock tailstock spindle with the
indexable knob (O).
Fig 32
Fig 33
The handle (Q) locks the tailstock in position on the bed.
The live centre can be ejected by turning the hand wheel
counter-clockwise.
To screw off the cone (R, Fig 35) the life centre must be
locked against rotation with the supplied pin (S).
The centre pin can be knocked out to allow deep hole
drilling operations.
7.7 Installing bed extension (# 6294905E)
Have an assistant hold bed extension flush to end of lathe
bed, and insert four screws with washers (B, Fig 36).
Snug screws just enough to hold bed extension to lathe
bed.
Unscrew stop bolt (A) from lathe bed and insert it into
hole at end of bed extension.
Fig 34
Fig 35