Fitting Instructions; Use And Maintenance - Umbra Rimorchi 29040 Instructions De Montage

Remove from below the vehicle any protective sealant from the points of contact between the shell and the
tow bar; then paint the parts with rust preventer. The holes for the tow bar fixing are available.
1. Remove the rear bumper and eliminate the bumper's reinforcement bar;
2. Remove the exhaust pipe's bearing and eliminate the masking tape placed in correspondence of
the fitting "1";
3. Place the frame with reference to the holes "1" and fix;
4. ONLY FOR PEUGEOT 1007: Before positioning the frame, refold upwards the two rims of the
4.
vehicle's rear part in the position of interference with the two tie rods of the cross bar;
5. Tighten all bolts and nuts as shown in the enclosed layout;
6. Connect the wirings to the socket, following the booklet's instructions "use and maintenance" given
with the car and in the enclosed wiring kit layout;
7. Reassemble together the exhaust pipe bearing and then reassemble together the bumper fixing with
the cross bar shown in point "2".
• Make sure that the tow bar is suitable for the vehicle before starting the installation. Verify also
that the vehicle's towing disposal quoted on the car registration is mentioned on the tow bar
document. Otherwise ask for the appropriate office (umbrarimorchi@umbrarimorchi.it) for
explanations or updated documents.
• For safety, all work involving tow bar installation must be undertaken by skilled technicians.
• Damaged components must be replaced with manufacturer's spares parts by qualified staff.
• It is forbidden to make any modification or structural repair to the tow bar.
• The tow ball must be kept clean and lubricated. For added safety, his diameter (50 mm) must be
checked at regular intervals. If the tow ball measures less than 49 mm after selected readings
across the diameter, the tow ball must be replaced with a new one.
• After 1000 km of towing, check torque settings for nuts and bolts, in accordance with the table.

FITTING INSTRUCTIONS

INVISIBLE AND SWIVELING SOCKETHOLDER
SAFETY INSTRUCTIONS

USE AND MAINTENANCE

Cod. 29040 • Rev. 1.1 • 12/08/2022