Control Elements; Installing The Refrigerator; Changing The Door Hinge - Waeco CoolMatic HDC-270 Instructions De Montage Et De Service

_HDC270.book Seite 35 Montag, 18. Oktober 2010 8:12 20
HDC-270
All materials used in the refrigerator are compatible for use with foodstuffs.
You can use the continuously variable thermostat to set the desired
temperature.
5.2

Control elements

No. in
fig. 3, page 4
1
2
3
6

Installing the refrigerator

6.1

Changing the door hinge

You can also change the hinge of the door, so that it opens to the left rather
than the right.
➤ Proceed as shown in fig. 4, page 5 to fig. 8, page 7 to change the
hinges.
6.2 Installing the refrigerator in the cabinet
NOTE
I
The dimensions for the cabinet can be found in fig. 2, page 3.
➤ Prepare the cut-outs for the cabinet as shown in fig. 2, page 3.
➤ Fasten the seal (fig. 9 A, page 7) to the side of the refrigerator opposite
the hinge (fig. 9, page 7).
➤ Push the refrigerator into the cabinet so that it touches the side without
hinges (fig. 9 B, page 7).
Description
Thermostat: the knob is for adjusting the temperature in the
refrigerator compartment.
Drain lever: opens the water drain of the freezer compart-
ment.
Type plate
Installing the refrigerator
35