Publicité
Les langues disponibles
Les langues disponibles
Battery
Warnings on batteries!
• Remove the batteries if they are empty or if
the product is not going to be used for an
extended period.
• Do not use different battery types or brands,
new and used batteries in combination, or
batteries with different capacities, as they leak
and can thus cause damage.
• Observe the polarity (+/-) when inserting
batteries.
• Change all batteries at the same time and
dispose of the old batteries properly.
• Warning! Batteries may not be charged or
reactivated in any way. They may not be dis-
mantled, thrown into fire, or short-circuited.
• Always keep batteries out of the reach of
children.
• Do not use rechargeable batteries!
• The cleaning and user-maintenance may not
be carried out by children without supervision.
• Clean the batteries and the device contacts as
necessary and before inserting the batteries.
• Do not expose the batteries to extreme
conditions (e.g. radiators or direct sunlight).
Otherwise there is an increased risk of leaks.
• Batteries can endanger life if swallowed. Keep
batteries out of the reach of small children for
this reason. Seek medical help immediately if
a battery is swallowed.
Danger!
• Handle a damaged or leaking battery with
extreme care and dispose of it properly and im-
mediately. Wear gloves to handle the battery.
• If you come into contact with battery acid then
wash the affected area with soap and water.
If battery acid gets in your eye rinse it out with
water and seek medical help immediately!
• Do not short-circuit the terminals.
12
GB/IE
Inserting/replacing batteries
(fig. C)
WARNING! Follow the following instruc-
tions to avoid mechanical and electrical
damage.
Insert the batteries included before first using the
product.
Inserting batteries
1. Using a suitable screwdriver (not supplied)
loosen the screw (4g) on the battery compart-
ment lid (4f) on the back of the locomotive
(4).
2. Remove the lid (4f) and carefully place two
batteries (13) in the battery holder (4e). The
batteries must be fully seated in the battery
compartment.
Note: Pay attention to the plus/minus polarity
of the batteries and their correct installation.
3. Screw back the lid (4f) tightly onto the back of
the locomotive.
Replacing batteries
If the batteries stop working, replace them using
the same process as described for inserting
them. Remove the batteries already in the prod-
uct before inserting the new batteries.
Note: Switch the product off before replacing
the batteries.
Assembly
In order to assemble the product follow the
individual steps as shown in figures D - H.
Assembly options
You will find options for assembly in the en-
closed overview.
Note: In the case of assembly options with
many consecutive curved sections the vehicles
could derail!
Clean the rails with a damp cloth before first
use!
Publicité
