Enabling Act - Zephyr Ombra ZOM-E30BS Guide D'utilisation, D'entretien Et D'installation

ZEPHYRONLINE.COM

Enabling ACT™

To enable ACT™:
1. Before hood installation, gain access to PC board by following the steps shown on FIG. E.
2. Change plastic jumper positioning as shown in FIG. F to set the desired maximum blower CFM.
3. Re-install PC board and continue with hood installation.
4. Remove the appropriate foil CFM sticker included with the hood literature and place inside the
hood body below the wiring diagram or in another clearly visible location.
To verify if your installer enabled ACT™:
1. With hood off, hold the On/Off button for five seconds. If speed 4 indicator illuminates = default
max. CFM, if speed 3 indicator illuminates = max. 390 CFM, and if speed 2 indicator illuminates =
max. 290 CFM.
2. There should also be a foil label located inside the hood body near the wiring diagram that
indicates the blower CFM.
NOTE: When ACT is enabled, the number of blower speeds will be reduced. 390 CFM = max. 3 speeds
and 290 CFM = max. 2 speeds.
1. Remove aluminum mesh filters.
2. Remove the screws attaching PC board cover.
Milano Use, Care, and Installation Guide
FIG. E
ACT™ Conversion
7 8
5 6
3 4
1 2
Max. Blower CFM
PC Board
FIG. F
Jumper Pins
Plastic
7 8 Jumper
5 6
3 4
1 2
J u m p e r 5 - 6 or 7-8
DEFAULT POSITION
Default Max. Blower CFM
7 8 7
5 6 5
3 4 3
1 2 1
J u m p e r 3 - 4 J u m p e r 1 - 2
Max. Blower CFM
390 290
8
6
4
2
23