Mectron multipiezo Manuel D'utilisation Et D'entretien page 23

FILLING AND CLEANING THE
IRRIGATION CIRCUIT
(Ref. 2 inside cover)
The appliance includes the "pump/flush"
key, which depending on the operating
mode allows the PUMP function or
FLUSH function to be run.
The PUMP function can be used at the
start of the treatment to allow the liquid
to reach the insert, so as to start the
surgery with the necessary irrigation (See
Chapter 5.4 on page 21
The FLUSH function (see
page 24 ) is used to run an irrigation
circuit cleaning cycle.
This function must be used after each
time the appliance is used and before
cleaning, disinfecting and sterilising all its
parts (See Chapter 8 on page 29
).
Chapter 6 on
).
USE
perio/scaler perio/scaler
restorative restorative
15