Warranty; Parts List - ITC Power SPT270 Guide D'utilisation

N Description
o.
1 Left Housing
2 Switch
3 Shockproof Pad
4 Diode IN4007
5 Motor RS365SH
6 Tapping Screw
7 Scew M2.5 x 6
8 Fan
9 Tapping Screw 3 x 8
10 Fan baffle
11 Regulator
12 Capacitor
13 Circuit Board
14 Terminal
15 Tapping Screw
16 Strain relief
17 Right housing
18 Hang Loop
!

WARRANTY

ITC branded power tools, air nailers staplers and compressors are designed for
use in DIY (do-it-yourself), light or intermittent duty, semi-professional applications.
They are not intended for use in professional, production, industrial or continual
use applications.
ITC makes every effort to ensure that its products meet high quality and durability
standards and are warranted for two years against manufacturers' faults and
defects for a period of two years from the date of purchase to the original owner.
ITC will REPAIR OR REPLACE (at our discretion) merchandise deemed by the
company to be defective, provided that it is has not been misused, abused, altered,
or repaired by anyone other than an authorized repair centre.
Please consult the ITC catalogue or your nearest ITC distributor to determine those
products that are covered by our over-the counter warranty. Any ITC tool that fails
during normal use and within the specified warranty period and qualifies for over-
the counter warranty must be returned to its point of purchase for replacement
or credit. Any item not listed as over-the-counter warranty must be shipped,
prepaid freight, to an authorized repair depot accompanied by a copy of the
invoice specifying the date that the item was purchased. Returned tools that are
not accompanied by a proof of purchase (Copy of Invoice) will not be repaired or
replaced under warranty.
This warranty does not extend to normal wear or consumable parts such as brad
and staple gun driver blades, grinding discs, saw blades, driver bits, electric motor
brushes, worn chords, etc. It also does not apply to ITC tools used in professional,
production, industrial or continual use applications.
For a listing of the authorized repair centers please refer to the ITC catalogue.

PARTS LIST

Please refer to the Schematic Drawing, p.14.
N
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
WARNING: Repairs should be made by an authorized repair centre. Opening this
tool could invalidate your warranty.
Description
o.
Cord Guard
Power cord
Tapping Screw
Location Sleeve
Ceramic Tube
Cover
Heating Wire
Ceramic Tube
Washer
Connector
Mica Sheet
Wind Tube
Wind Tube Ring
Wind Tube Sheath
Tapping Screw
Motor Mount
Label
7
v.081125