Specifications; Features; Attachments; Operating Procedures - ITC Power SPT270 Guide D'utilisation

!
!

SPECIFICATIONS

Your new SPT270 comprises:
u Heat Gun
u 4 nozzles
u 5 piece Paint Scraper Kit
• shavehook scraper: 1 handle with 3 blades
•flat paint scraper
u Case

FEATURES

n Voltage: 120 volts AC, 60Hz.
n Current rating: 1500 watts, 12.5 Amps
n Dual heat & fan settings:
I 1,000 W Air Speed: 1,128'/min (400m/min) @ 375°C/ 700°F
II 1,500 W Air Speed: 1,551'/min (550m/min) @ 495°C/ 925°F
n Hanging loop doubles as a support for vertical bench top operation
n Double insulation
n C-UL listed
n Tool weight: 1.8 lb. / 0.8 kg
n Pkg. weight: 4 lb. / 1.8kg

ATTACHMENTS

Your Heat Gun Kit includes several attachments for a multitude of applications.
WARNING: Never attempt to install or remove attachments when heat gun is
turned on or is hot.
1. Window/Glass / Wide Nozzle - This nozzle is helpful for working in areas where
heat must be deflected away from glass panes. Heat is focused in a wide
pattern, but deflected to protect panes of glass, etc. from overheating and
cracking.
2. Hook Nozzle - This nozzle can be used to wrap around piping, shrink wrap, and
other cylindrical work areas to radiate and reflect heat.
3. Reduction Nozzles - These nozzles promote a focused blast of heat. When
direct, controlled heat application is required, use reduction nozzles.
4. Paint Scraper Kit - Included are three scraper blades and a scraper handle.
One for flat surfaces, one for concave surfaces and one for convex surfaces.
Install appropriate blade for your work surface to scraper handle. Apply heat
to your work surface and scrape with blade as needed. Never attempt to use
scraper blades without the help of the scraper handle.

OPERATING PROCEDURES

1. Plug Heat Gun into standard 120 volt wall socket.
2. Before starting, it may be advisable to test the tool and attachment on a piece of
scrap material to gauge the effect of the heat.
3. Always begin at the lower setting.
4. For lower heat settings (700° F/375° C) toggle trigger switch to downward LOW
(I) position. For higher heat setting (1000° F/500° C)toggle trigger switch to
upward HIGH (II) position.
5. Direct nozzle at materials. Never aim nozzle at people, animals, or flammable
materials.
6. Hold the nozzle a minimum of 2" (50mm) from the work surface.
7. When finished return trigger switch to center OFF (0) position.
8. When finished, unplug the tool.
9. Allow the tool to cool, setting it down on the black intake cap at the back of the
tool, with the nozzle pointing up and the metal tool hanger loop supporting the
handle.

PAINT REMOVAL

1. Select the flat paint scraper or, by bolting a scraper blade matching the profile
you are stripping, to the handle supplied, assemble the shavehook style paint
scraper.
5
v.081125