SEVERIN KA 5827 Mode D'emploi page 11

∙ Do not leave the appliance unattended
while it is switched on.
∙ No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
Cable storage compartment
There is a cable storage compartment at the
rear of the appliance. Pull out the cord to the
required length before use.
Automatic switch-off
To save energy, models with a thermo jug
will switch off automatically once the brewing
cycle has been completed.
Before using for the fi rst time
Before making coffee for the fi rst time, let the
appliance go through two or three fi ltration
cycles, using the indicated maximum amount
of cold water but without any coffee. This
procedure should also be gone through
if the appliance has not been used for an
extended time, and after descaling.
General information
∙ The markings on the water reservoir help
you to measure the amount of water
needed to prepare the required number of
cups of coffee. The scale on the left-hand
side corresponds to medium-sized cups
with a capacity of approx. 125 ml; the
one on the right to smaller-sized cups.
Take care not to exceed the indicated
maximum number of cups. Take care not
to exceed the indicated maximum number
of cups.
∙ If several consecutive brewing cycles
are required, switch off the machine after
each cycle and let it cool down for approx.
5 minutes.
∙ Warning! Be careful not to put water into
the reservoir immediately after a brewing
cycle, as hot steam may escape from the
water nozzle.
To prepare fi lter coffee
Filling the water reservoir:
Open the water reservoir lid. Fill the reservoir
with the required amount of fresh cold water
and close the lid.
Inserting the paper fi lter:
Place a paper fi lter size 1x4 into the fi lter
holder, fi rst folding down its perforated sides.
Adding ground coffee:
We recommend using fi nely ground fi lter
coffee, approximately 6 g = 1½ - 2 tsp. per
medium-sized cup (125 ml).
Preparing the jug:
Place the aroma-protection lid onto the jug.
If correctly fi tted, the lid will disable the drip-
stop mechanism in the fi lter holder during the
brewing cycle.
Replace the jug in the appliance.
Starting the fi ltering process:
Insert the plug into a suitable wall outlet and
use the On/Off button to switch the coffee
maker on. The fi ltering process begins.
Removing the jug:
When the fi ltering process is complete, i.e.
all water has run through the fi lter into the
jug, remove the jug to serve the coffee.
The ma chine will switch off automatically
once the brewing cycle is complete.
Interrupting the brewing cycle:
To interrupt the brewing cycle, press the On/
Off button again to turn the appliance off.
Switching the coffee maker off:
Remove the plug from the wall socket once
brewing is complete.
11