L-Acoustics KUDO Multi-Mode WST Manuel D'utilisation page 16

® ® ® ®
KUDO KUDO KUDO KUDO
multi- - - - m m m m ode multi multi multi
user r r r manual use use use manual manual manual
VERSION 2.0
!
To ensure both high performance and safety, L-ACOUSTICS
high-quality, fully insulated speaker cables made of stranded copper wire.
In order to preserve a high damping factor it is desirable to keep loudspeaker cables as short as
possible and with a gauge offering low resistance per unit length.
IMPORTANT
The following table provides information regarding the recommended cable length versus conductor cross-section.
Three cases are possible depending on the impedance load connected to the LA8 (8
®
4 for two KUDO enclosures in parallel, and 2.7
Table 1: Maximum cable length versus conductor cross-section for Damping Factor > 20
Cross-section
2
mm SWG AWG
2.5 15 13
4 13 11
6 11 9
10 9 7
According to the calculation in Table 1, one DO25 cable (4 mm², 25 m) can be used to power two KUDO
(4 load) with a damping factor still greater than 20.
KUDO_UM_ML_2-0
® ® ® ®
ode wst ode ode wst wst wst e e e enclosure nclosure nclosure nclosure
for three KUDO
®
Length for one KUDO
(8 load)
m ft
30 100
50 160
74 240
120 390
w w w . l - a c o u s t i c s . c o m
®
recommends the exclusive use of
®
enclosures in parallel):
®
Length for two KUDO
(4 load)
m Ft
15 50
25 80
37 120
60 195
®
for a single KUDO enclosure,
®
Length for three KUDO
(2.7 load)
m ft
10 33
17 53
25 80
40 130
®
in parallel
14 en 14 14 14