Replacing Blades; Storage; Disposal/Environmental Protection - Parkside Performance Pprma 40-Li A1 Traduction Des Instructions D'origine

• Do not dismantle any safety compo-
nents (e.g. impact protection), otherwi-
se safe use of the machine cannot be
guaranteed.

Replacing blades

If the blade is blunt, it can be re-sharpened
by a specialist company. If the blade is da-
maged or unbalanced, it must be replaced.
Illustration
:
1. Turn the machine over or set up the ma-
chine, see chapter "Storage – Setting
up the machine".
2. Use sturdy gloves and keep hold of the
blade (30).
3. Use a spanner (AF 14) to turn the bla-
de bolt (31) counter-clockwise from the
motor spindle.
4. Reassemble the new blade (30) in re-
verse order.
Make sure that the blade (30) is
positioned correctly and that the
blade bolt (31) is tightened.

Storage

Fold up the machine, Illustration
1. Turn the quick release levers (6) cros-
swise towards the bar.
2. Open the tightening levers (4).
3. Fold the upper bar (1) and the lower
bar (14) together.
Make sure not to pinch the machi-
ne cables while doing this.
Set up the machine, Illustration
1. Turn the quick release levers (6) cros-
swise towards the bar. Gently pull the
quick release levers (6) away from the
lower bar (14).
2. Fold the lower bar (14) onto the machi-
ne housing.
3. Turn the quick release levers (6) back to
their original position.
The quick release levers (6) must
engage in the holes on the machi-
ne housing.
4. Set up the machine.
• Store the device in a dry place out of
reach of children.
• Give the motor time to cool off before
you store the device in an enclosed
space.
• Remove the rechargeable battery
before storing the device for a long
period of time (e.g. winter storage).
• The storage temperature for the re-
chargeable battery and the device is
between 0°C and 45°C. Avoid extreme
cold or heat during storage to ensure
the battery output is not adversely af-
fected.
We are not liable for damage cause by
our devices if this is caused by improper
repair, the use of non-original parts or in-
correct use.
:
Disposal/environmental
protection
Remove the rechargeable battery before
disposing of the device.
The device, accessories and packaging
should be properly recycled.
Electrical devices do not belong in
:
domestic waste.
In accordance with the Directive
2012/19/EU on waste electrical and
GB MT
41