Removing Blockages; Difference Between Moving And Mulching Lawns; Connecting The Device To The Parkside App - Parkside Performance Pprma 40-Li A1 Traduction Des Instructions D'origine

Choosing a cutting height that is too
high can also cause the blade to be
blocked by the long grass. Please refer
to chapter "Removing blockages".
• Always move across slopes crosswise.
Take special care when going back-
wards and pulling the device.
• Clean the device after each use, as
described in the section "Cleaning/
storage".
After switching off the equip-
ment, the blade continues to
turn for several seconds. Do
not touch the moving blade.
There is a risk of injury.

Removing blockages

Switch off the machine, remove the
safety key (23) and wait for the bla-
de to come to a stop.
1. Turn the machine over or set up the ma-
chine, see chapter "Storage – Setting
up the machine".
2. Use sturdy gloves and remove the
blockage from the blade (30).
Difference between moving
and mulching lawns
When using the mulch kit (21), the grass
clippings are not captured in a collection
box but are instead shredded and spread
across the lawn. The nutrients contained
in the clippings are thus left to be broken
down by soil organisms and form a nu-
trient cycle. Mulched lawns therefore need
to be fertilised much less frequently.
As a basic rule, the lawn has to be mowed
relatively often so that only small amounts
of mulch remain on the lawn.
It is therefore best to mulch the lawn at
least once a week and to adjust the mower
so that only about 40% of the total height
of the lawn is left as mulch. If the mulch
remains visible on the lawn (for example
when cutting the lawn for the first time
of the year or during strong growth), the
grass collection bag (12) should be used.
Connecting the device
to the Parkside app
Only Smart Performance batteries
can be connected to the Parkside
app. The device connects to the app via
the battery.
1. Insert Smart Performance batteries
(24) into the device. You will hear them
click into place.
2. Press the button for the charge level
indicator (20).
The device is now activated and the
Smart LED
3. Enable Bluetooth
4. Open the Parkside app.
5. Select .
If you have already connected
the Smart Performance battery
you are using the device with to the
app, you will find the device in the list
of connected devices.
6. Select the device from the list.
If it is not available, connect the devi-
ce to the app as follows:
Add device" or, if you have
1. Select "
already paired devices/batteries, the
at the top right.
2. Follow the instructions in the app. The
app scans the surroundings for available
GB MT
(18) flashes (briefly).
® on your smartphone.
39