Sandri Garden GI3000 Mode D'emploi page 13

machine body.
To assemble the grass collection basket
proceed as follows:
• Fit the support rod in the specific holes
in the plastic cover (Fig. E1).
• Fasten the elastic profiles stitched to
the cloth onto the "U" rod (Fig. E2).
Fitting the grassbox to your mower:
• Raise the spring loaded rear door, move
the basket up to the machine body and
fasten it on to the coupling hooks (Fig.
E3).
• Release the rear door so the basket is
fastened in position.
Removing the grassbox from your
mower:
The full basket can be moved by raising
the door (5) and freeing the basket from
its support.
8) HOW TO USE YOUR
MOWER (FIG. F, G & H)
Observe all of the relevant warnings
when using your mower.
• Push the loop of cable through the slot
from the opposite side of the restraint
hook (Fig. F), position the loop over
the hook and pull the cable back
through the slot. Your cable will now
be restrained.
We recommend the directional method of
operation to obtain the maximum cutting
performance from your mower and to re-
duce the risk of the trailing the extension
lead from entering the cutting path.
INSTRUCTION MANUAL
•
•
•
•
Your mower will continue to operate whilst
you are pulling the switch lever. To stop
your mower release the switch lever.
When you have finished using your mower
we recommend that you clean all debris
Place the bulk of the supply cable on
the lawn close to the starting point (see
Fig. H, position 1).
Hold the handle assembly with both
hands.
Warning! Do not attempt to operate
your mower with one hand - you must
guide it with both hands.
Tilt the handle downwards to slightly
raise the front of your mower and to
reduce the risk of lawn damage whilst
starting, depress the safety lock-off
button (12) on the switchbox (10) and
whilst still depressed pull the switch
lever (11) towards you. Your mower will
start and you can now allow the lock-
off button to be released and lower your
mower to its proper cutting position,
and commence cutting.
Proceed down the cutting area as
shown in Fig. Ha, working from position
1 towards position 2 and, on reaching
position 2, turn to the right and proceed
towards position 3. Continue to the end
of the cutting area, turn to the left and
proceed towards position 4. Continue
in the same manner as shown in Fig.
Ha, always working away from the
cable. Do not adopt the method as
shown in Fig. Hb, working towards the
cable, as this is dangerous practice.
UK
11/
60