Parkside Performance PRDSP 20-Li C2 Instructions D'utilisation Et Consignes De Sécurité page 52

– Impermeable gloves resistant to plant
control chemicals
– Snug-fitting safety glasses in accordance
with European standard EN 166
– Suitable respirator
Accessories are available through your
authorised dealer . When buying, always
consider the technical requirements of this
product (see "Technical data") .
If you are not certain, ask a qualified
specialist and get advice from your trusted
dealer .
NOTE
u
This instruction manual contains
information on battery pack and charger .
Battery pack and chargers are not
included in the delivery (see "Scope of
delivery") .
˜ Features
Spray tank: The capacity of the spray
[ 3 ]
tank is 16 litres .
Trigger: Squeezing the trigger
releases a stream of spray solution for
spraying consumer-grade home and
garden chemicals .
Lock-on latch: The lock-on latch
enables continuous spraying without
holding down the trigger .
Power button: The power button
switches the product on or off and adjusts
the spray pressure .
Battery cover: The battery compartment
[ 5 ]
cover protects the battery pack from
exposure to liquids .
Filter: The basket filter
36 ] [
small filter are used for filtering solid
substances .
Nozzle: The nozzle accessories
the cone spray head
enable different spray patterns and flow
rates .
Battery level indicator: The battery
21 ] [
level indicator
charging level of the battery pack
50 GB/IE
[ 28 ]
35 ] [
[ 14 ]
26 ] [
and the
12 ] [
and
33 ] [
are provided to
is used to indicate the
[ 18 ]
.
Shoulder strap: In case of emergency,
the product can be released from the
operator quickly by lifting the lower end
of the tab on both sides of the shoulder
[ 6 ]
strap (Fig . P) .
˜ Battery pack
˜ Charging the battery pack
Fig . C
NOTE
u
The battery pack
any time without reducing battery life .
u
Interrupting the charging process does
not damage the battery pack
u
Charge the battery pack
operation when it is at medium or low
charging level .
1 . Insert the battery pack
23 ] [
battery charger
2 . Connect the power cord with power
[ 22 ]
plug to a socket-outlet .
3 . The charging control LEDs (green
[ 24 ]
and red ) indicate the status of the
rapid battery charger
18 ] [
pack :
LEDs
Red LED lights up
Green LED lights up
Green and red LED
flashing
Red LED flashing
Green LED lights up
(without battery pack) Charger ready
When the battery pack
o
– Remove the battery pack
rapid battery charger
– Disconnect the power cord with power
[ 22 ]
plug from the socket-outlet .
18 ] [
may be charged at
[ 18 ]
.
18 ] [
before
18 ] [
into the rapid
.
[ 25 ]
23 ] [
and the battery
Status
Battery pack charges
Battery pack fully
charged
Battery pack defective
Battery pack too cold
or too warm
[ 18 ]
is fully charged:
18 ] [
from the
[ 23 ]
.