FITFIU FITNESS BELI-100 Manuel D'utilisation page 52

• The bicycle must be moved and transported with care to avoid injury.
• The part of the brake is the one that wears out most easily. Before using the bicycle check that the brake system
works well.
• Check that the fastening elements are securely tighten.
• Carefully inspect the parts that are most likely to wear.
• Replace defective parts immediately.
• Keep the appliance out of service until it is repaired.
• Please check that all safety labels are in good condition and can be read. If there are some missing or damaged
labels, contact your distributor to request new ones.
TROUBLESHOOTING
Problem
1. To change the batteries in the computer, slide it from the holder, remove the battery cover
To change the
batteries 2. Replace the batteries with 2 new AA batteries as specified above.
3. Finally, replace the cover on the console and slide the computer back into the holder.
The equipment 1. If the computer does not work properly, check if the computer's sensor cable is plugged in.
does not work 2. If you have checked the above and the computer still does not work, make sure that the
correctly
1. If there is no resistance to the tension, turn the tension adjustment knob to its lowest level,
There is no
2. Loosen the friction belt, pull it through the buckle until you can feel some resistance in the
resistance
3. Now get on your cross trainer and spin the pedals.
4. If you find that it is too tight, return to the friction belt buckle and loosen it slightly.
NOTE: If after checking the settings and the device, you cannot use the product, call FITFIU
Technical Service.
TRANSPORT
The incorporated wheels on the base allow you to move this product very easily.
from the back of the console and remove the batteries.
batteries are still working and that they are installed correctly in the computer.
and then check the buckle of the friction tape that is located on the top of the fan wheel
below the central bar.
belt, and then secure it around the buckle.
Solution
52