Publicité
Les langues disponibles
Les langues disponibles
When used above water, keep at least 50cm clearance from the front of
the spotlight.
The lighting is intended for use in fresh water with a temperature range
of + 4 ° C to + 35 ° C.
The transformer heats up during operation. The area must be well-
ventilated to ensure proper cooling.
Do not place or mount it on a flammable surface.
Commissioning (figures 1, 3 and 4, pages 2, 3 and 4)
Observe the safety instructions!
Place the light as shown in figure 3 and 4, page 3 and 4.
Connect the connecting cable of the lamp(s) to the transformer.
Turn on the light by plugging the transformer's power cord into the
electrical outlet.
The transformer may be used outdoors.
Maintenance
Follow the safety instructions.
Maintenance of lighting consists of regular cleaning of the spot light and
the glass.
Clean the lighting in warm water with a soft brush or cloth
Replacing the lamp
Unplug the transformer from the outlet, so that the power is interrupted.
If the lamp is in water, remove this from the water.
Make the spot light clean and dry.
Turn off the glass ring on the front of the spotlight.
Take the glass from the spot light, take care about the seal.
Remove the bulb from the spot light and disconnect it from the lamp
holder.
Replace the lamp with a lamp with the same power and performance
(see label).
Connect the lamp socket on the lamp and put it back in the spotlight.
Make sure that the seal is in good position and put the glass back on the
spotlight.
Turn the glass ring on the spotlight. Tighten by hand.
If all is well is placed back, the spotlight can again be activated by
plugging the
transformer into the outlet.
Winter period
Protect the light from frost and the LEDs from freezing in the water as
this may cause damage.
Take the light out of the water before the frost season begins.
Clean the light as described earlier, before putting it in storage.
Store it in a dry and frost-free area.
English
www.auga.nl
17
Publicité
