BE QUIET! PURE POWER 12 M 1200W Mode D'emploi page 8

you plug the connector into the socket� If you have a motherboard with a 20-pin
connector, fold the additional 4 pins to one side�
∙ Now plug the 12V-P4 or P8 connector for the CPU into the socket provided on the
motherboard�
5. SAFETY FUNCTIONS
All be quiet! power supplies have numerous safety functions� They are designed to
protect the power supply and the components connected to it against damage� If one
of these safeguards is triggered, the system will reboot or power off in most cases� If
this happens, you should immediately check the PC for errors�
For more info on troubleshooting see the "Troubleshooting" chapter�
The be quiet! Pure Power 12 M series has the following safety functions:
OCP (Over current protection)
If the load on the individual circuits exceeds the specified limit, the power supply is
automatically switched off�
UVP (Undervoltage protection)
This safeguard is triggered if the voltage on the circuits drops below a certain limit�
The power supply is automatically switched off in this case�
OVP (Overvoltage protection)
The overvoltage safeguard is triggered if the voltage in the circuits is too high; the
power supply is deactivated�
SCP (Short circuit safeguard)
The fuse protecting the power supply's secondary circuits prevents physical defects
of the power supply and the components connected to it�
OTP (Temperature safeguard)
In the case of excessive heat build-up in the power supply, the power supply
immediately and automatically switches off� You cannot switch it back on until it has
cooled down� Please ensure that the PC has sufficient cooling�
OPP (overload protection)
This safeguard is triggered if the total output of the power supply exceeds the
specified maximum load� This can happen if the output of power supply is insufficient
for the system (incorrectly dimensioned)�
8