Table des Matières
Publicité
1. Introduction
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, do not install or use it and contact your dealer.
2. Safety Instructions
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
• Damage caused by user modifications to the device is not covered by the warranty.
• Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
• Check the contents prior to assembly. Use proper tools and never use defective or deformed parts
as an improper installation may cause serious injury.
• Any included hardware is for mounting on solid brick, concrete or hard wood battens.
When mounting on wood, do not use any concrete anchors. Do not use any included hardware for
mounting on steel. If uncertain about the nature of the wall or mounting techniques, please
consult an expert.
• Respect the product's max. load specifications. Protect this device from shocks and abuse and
avoid brute force when operating. Check the installation on a bimonthly basis.
• An adequate mounting is essential and falls outside the responsibility of Velleman nv. Respect all
installation and operating directions of the device to be mounted/installed (LCD/plasma display).
• Only use the device at an indoor location, protected from rain, moisture, splashing and dripping
liquids. Make sure the chosen location spot is able to support the weight of the bracket and
screen.
• Keep fingers away from articulations to avoid injury. Keep the device out of reach of children and
unauthorized users at all times.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
4. Features
• for LCD/plasma TV
• easy installation
• in accordance with VESA standard 200/400/600/800 x 400mm
• comes with all necessary plugs and screws for assembly and mounting
5. Installation
Refer to the illustrations on pages 2 and 3 of this manual.
1) Illustration [1] shows and overview of the mounting bracket assembly.
a
b
f
o
r
2) Use the wall mounting bracket to determine and indicate the position of the mounting holes.
Use 6 screws, 3 on top and 3 at the bottom of the plate. The distance between the holes must
be at least 200mm and the outer holes must fall to the left and right of the large holes in the
middle of the plate.
When mounting on a brick or concrete wall, drill holes (at least 60mm deep) at the indicated
positions. Insert the included anchors [e] and mount the wall mounting bracket on the wall
using the 6 included screws [d].
When mounting on a wooden wall or wall support, drill holes size Ø3mm and at least 60mm
deep at the indicated positions. Make sure all the holes are drilled in solid wood and that they
are blind holes. Mount the wall mounting bracket on the wall using the 6 included screws [d].
3) Mount the TV mounting bracket on the back of the TV as close as possible to the centre [A]
and aligned with the top of the TV-screen [B].Depending on the TV screen, use the correct
bolts [g], [j],[k], [m] or [n], together with the correct washers [h]. Make sure that the
threaded inserts of the TV are deep enough to tighten the bolts without damaging the TV.
When necessary (e.g. curved TV-back, bolt too long), use the included plastic spacers [i].
4) Hook the TV with the TV rails [b] over the wall plate [a].
26/04/2011
User manual
wall plate
TV rail (2x)
safety bar
TV rail hook (when necessary)
opening for lock (not included)
WB013
4
Rev. 01
©Velleman nv
Publicité
Table des Matières
