Safety Symbols - NOCCHI DPC 200/10 Manuel D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
GB
Take the time to read the instructions carefully before using this appliance.
Thank you!
Chap. 1
Chap. 2
Chap. 3
Chap. 4
Chap. 5
Chap. 6
Chap. 7
Appendix
Warnings for the safety of individuals and objects.
Carefully follow the instructions marked with the following symbols.
DANGER
Electric shock
risk
DANGER
WARNING
Chap. 1 - Safety rules
Before installation, carefully read this manual and keep in a safe place. The guarantee will not cover any damage
resulting from failure to comply with the instructions provided by this manual.
On receiving the pump, check that the pump has not been damaged during transportation. If the pump is damaged,
immediately inform the dealer within 8 days from the date of purchase.
Keep the equipment out of reach of children under 16.
Do not transport the pump using the cable or use the cable to remove the plug from the socket.
Before using the pump, always inspect it visually (especially power cable and plug). Do not use the pump if it is
damaged.
If the pump is damaged, have it inspected by the specialised assistance service only.
Verify that the voltage and frequency of the electropump shown on the nameplate correspond to those available on the
mains.
Make sure that electric connections are protected from inundation.
Make sure that the level of water is below the minimum start level referred to in the "Technical Data".
Before starting the pump, make sure that the delivery pipe is free from obstructions.
Supply cables and extensions should have a section below that of H05 RN-F. The plug and connections should be
protected by water splashes. All extensions must comply with DIN VDE 0620 standard.
6
Contents
Safety rules ............................................................................... pg.
Limitations ................................................................................. pg.
Technical data ............................................................................ pg.
Installation ................................................................................. pg.
Electrical connections ................................................................ pg.
Start-up ...................................................................................... pg.
Maintenance and troubleshooting .............................................. pg.
Figures ....................................................................................... pg. 91

Safety symbols

Warns that the failure to follow the directions given may cause
electric shock.
Warns that the failure to follow the directions given could cause
serious risk to individuals or objects.
Warns the operator that the failure to follow an instruction may damage
the pump and/or the system.
1
GB
1
GB
2
GB
2
GB
3
GB
3
GB
4
GB
5
GB

Publicité

Table des Matières
loading

Table des Matières