DeLonghi PALACE 1800/1 Mode D'emploi Et D'installation page 26

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
The radiator
heats up
when not
requested
The radiator
does not
heat up
The radiator
does not
heat up
The radiator
does not
heat up
A crossed-out wheelie bin symbol on the product means that all electrical products in the
European Union are subject to special collection at the end of their life cycle.
DO NOT dispose of these products with unsorted household waste.
At the end of the product's life, the appliance must not be disposed of with common
household waste but must be delivered to a special collection centre in the region in
question. Alternatively, the product can be returned to the distributor after buying a new
appliance of the same type and use. Separate collection of electrical and electronic appliances
is an integral part of a policy on preserving, protecting and improving the quality of the
environment; this is designed to avoid potentially harmful effects on human health due to
the presence of hazardous substances, thus classified by European regulations.
[Fig. 19]
The manufacturer, DL RADIATORS srl Via delle Industrie, 2, Fossalta di Piave, 30020
ITALY, declares that the electric panel heater models:
CERTIFICATE NAME
are manufactured in compliance with European Directives: Directive 2014/35/EU and 2014/30/EU.
And in compliance with harmonised standards:
- EN 60335-1:2012 + A11:2014 + A13:2017 : Safety of household and similar electrical
appliances, general requirements.
- EN 60335-2-30:2009 + A11:2012 : Safety of household and similar electrical appliances.
Part 2 : Particular requirements for room heaters.
- EN 62233:2008
- EN 55014-1: 2000 + A1: 2001 + A2: 2002
- EN 61000-3-2: 2000
- EN 61000-3-3: 1995 +A1: 2001
- EN 55014-2: 1997 + A1: 2001
- EN 61000-4-2: 1995 +A1: 1999 +A2: 2001
- EN 61000-4-4: 1995 +A1: 2001 +A2: 2002
- EN 61000-4-5: 1995 +A1: 2001
- EN 61000-4-6: 1996 +A1: 2001
- EN 61000-4-11: 1994 +A1: 2001
25
TROUBLESHOOTING
Possible cause
Program mode is
selected and the
time is flashing
Program mode is
selected and there
is no bar for the
current time
A low temperature is
set, or is very close to
the room temperature
The temperature
sensor is covered
DISPOSAL
INTERNATIONAL STANDARDS
Solution
Adjust the date
and time
In this case, the night
reduction temperature
is set: change the
daily program.
Check operation of the
radiator by adjusting
comfort mode to a
temperature of 25°C.
Check that the bottom
of the radiator is not
covered and is at least
20 cm off the ground.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Palace 1800/2Palace 1800/3Palace 1800/4

Table des Matières