Thank you for having chosen our AFX LIGHT effect. For your own safety, please
read this user manual carefully before installing the device.
SAFETY INTRODUCTION
• If the device has been exposed to temperature changes due to environmental
changes, do not switch it on immediately. The arising condensation could
damage the device. Leave the device switched off until it has reached room
temperature.
• It is essential that the device is earthed. A qualified person must carry out the
electric connection.
• Make sure that the available voltage is not higher than stated at the end of this
manual.
• Make sure the power cord is never crimped or damaged. If it is damaged, ask
your dealer or authorized agent to replace the power cord.
• Always disconnect from the mains, when the device is not in use or before
cleaning it. Only handle the power cord by plug. Never pull out the plug by
tugging the power cord.
• DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used
as the disconnect device, the disconnect device shall remain readily operable.
• Due to the magnifying type lens, please keep the lens out of contact with direct
us. Direct we can cause heat to build up inside of the unit, which will seriously
damage unit.
CAUTION:
1. Be very careful during installation. Since you will be working with a dangerous
voltage you can suffer a life-threatening electric shock when touching live wired.
2. Never look directly into the light source, as sensitive persons may suffer an
epileptic shock.
GB
2