Costway NP10907 Mode D'emploi page 3

Set up instructions
1.Remove the Bouncer from the carry bag.
Place the Bouncer on a level surface at least
2M from any structure or obstruction such as a
fence, garage, house, overhanging branches,
laundry lines or electrical wires.
2.Check the ground where the Bouncer is to
be inflated for any sharp objects or unusual by
products. Do not install the Bouncer over
concrete, asphalt or any hard surface.
3.Set up away from water and any potential
fire hazards.
4.Set up as near to power source as possible.
After stretching the air fill tube, position the
blower(air pump) at the end of the tube. Push
ground stakes for air blower through blower
base holes firmly to the lawn ground. (Refer to
picture 1)
5.Slide the end of the tube around the blower
(air pump) nozzle and tighten the string.
6.The air fill tube should be straight and
untwisted. Reposition the blower(air pump) if
necessary.
7.Make sure that the blower(air pump) "on/off"
switch is in the off position.
8.Plug the blower into an approved grounded
outlet.
04
1
2
3
4
5
9.Keep the blower(air pump) and power cord away from water and
moisture.If water contacts the blower(air pump), unplug the blower(air
pump) power cord. Do not operate until the blower is completely dry.
10.Ensure that the blower(air pump) is free from debris and securely
sited to avoid tripping. To inflate the bouncer unit, (press the reset button
on GFCI) turn the blower (air pump) "on/off" switch to on. The continual airflow
blower (air pump) must be left on at all times while the Bouncer is
being used. (Refer to picture 2)
11.If the product comes with water bags, please follow the undermentioned
instruction, otherwise, overleap this point. Spread out the product, place
and fasten the empty water bags at the two sides of the product. Open the
stopple and fill water in the water bags until 80% full (about 22kg), push and
close the stopple. Make sure that the water bags are firmly attached on the
product and no water leakage before the product is fully inflated, and never
allow children to play on the side without installing water bags. (Refer to
picture 3)
12.The Bouncer should take less than 2 minutes to inflate.
13.If the product comes with slide extension, please follow the
undermentioned instruction, otherwise, overleap this point. Add the Slide
extension to the end of the Slide using the hook and loop fastener. (Refer to
picture 4)
14.Ground support stakes are used for lawn ground surfaces. Hook stakes
over loops in the Bouncer. To prevent overturn or lift during play, push
the stakes firmly into the soil. The stakes should be placed level with or
under the ground in order to reduce tripping hazards. (Refer to picture 5)
15.To prevent overturning during play, periodically check that the ground
stakes are securely in place. To anchor the product properly, ALWAYS
anchor the product and blower with corresponding ground stakes before
use.
05