Operation - Cameo NANOSCAN 100 Manuel D'utilisation

OPERATION

A few seconds after connecting to the power supply, the projector is ready for operation and the operating mode that was previously
selected is activated.
SELECTING THE DMX START ADDRESS
Press the MODE button repeatedly until "Addr" appears on the display. Press ENTER, and while all four characters are flashing on the
display, the DMX start address can be set as desired using the UP and DOWN buttons (A001 - A512). Confirm the input with ENTER. The
synchronous control of multiple spotlights (same model) through a DMX control unit (e.g. DMX console) can be achieved by assigning the
spotlights to an identical DMX start address and DMX mode and connecting them using DMX cables.
-> ENTER ->
ADJUSTING THE OPERATING MODE
Press the MODE button repeatedly until "MOdE" appears on the display. Press ENTER, and select the desired operating mode using the UP
and DOWN buttons (DMX 2Ch, 8Ch, 10Ch, SLAv, AUtO, SOUn). Confirm the input with ENTER. You will find tables with the channels of the
different DMX modes in this manual under DMX CONTROL.
-> ENTER ->
SLAVE MODE
As previously described in SETTING THE OPERATING MODE, select the Slave operating mode and confirm by pressing ENTER. Connect the
slave and the master unit (same model) with a DMX cable and activate one of the standalone modes (AUTO, SOUND) on the master unit.
Now the slave unit follows the master unit.
AUTOMATIC CONTROL MODE (AUTO)
Select one of the 17 different Auto programs (AU00 - AU16) and adjust the program speed (SP00 - SP99). As previously described in
SETTING THE OPERATING MODE, select the Auto operating mode and confirm by pressing ENTER. While the characters are flashing on the
display, the program can be set as desired using the UP and DOWN switches. Confirm with ENTER. Now you can set the program speed
from 0 to 99, as desired, using the UP and DOWN switches (0 = minimum speed, 99 = maximum speed). Confirm with ENTER. If no further
input is given, the flashing stops after approx. 10 seconds and the program number is shown on the display.
-> ENTER ->
MUSIC CONTROL MODE (SOUND)
Select the Music control mode, to control the spotlight via the built-in microphone (bass pulses). Select one of the 17 different Sound programs
(SO00 - SO16) and select the microphone sensitivity (SE 0 - SE99) as desired. As previously described in SETTING THE OPERATING MODE,
select the Music control mode and confirm by pressing ENTER. While the characters are flashing on the display, the program can be set as
desired using the UP and DOWN switches. Confirm with ENTER. Now you can set the microphone sensitivity from 0 to 99, as desired, using
the UP and DOWN switches (0 = minimum sensitivity, 99 = maximum sensitivity). Confirm with ENTER. If no further input is given, the flashing
stops after approx. 10 seconds and the program number is shown on the display.
-> ENTER ->
6
–
UP/DOWN
UP/DOWN
/
/
–
UP/DOWN
–
UP/DOWN
-> ENTER
<- MODE
/
-> ENTER
/
<- MODE
-> ENTER ->
UP/DOWN
<- MODE
-> ENTER ->
UP/DOWN
<- MODE
-> ENTER
–
<- MODE
-> ENTER
–
<- MODE