Livington AIR COOLER VHGVACIND 0367 Mode D'emploi page 4

damaged by water, for example, wood.
• Do NOT use the adaptor, if either the
cable or plug is damaged. If the unit
is incorrectly repaired or reassembled,
it may cause an electrical shock or
injure people during use.
• Only use the adaptor for its intended
purpose.
• NEVER leave the unit unattended
while plugged in.
• Only use manufacturer recommended
accessory parts.
• Do not carry the Livington Air Cooler
around while it is filled with water.
• Only use clean water. For heavily
calcified water, use distilled water.
• Please read and follow the
recommendations in the "Cleaning
and Maintenance" section of this
manual.
• The Livington Air Cooler
best in clean areas. Large amounts of
dust and dirt particles can affect the
durability of the unit.
• We recommend use only in dry areas.
For use in a damp environment, make
sure that no water finds its way onto
the housing of the product.
• Should water find its way onto the
product, disconnect the Livington Air
Cooler power supply and leave to dry
®
for 24 hours. Then use again as usual.
• Do not expose to direct sunlight for a
long period of time.
• If you plan to no longer use the
Livington Air Cooler
tank, switch the unit on and leave it to
4
performs
®
, empty the water
®
run for at least 4 hours at the highest
level. As a result, the filters and the
unit' s interior will be dried.
• Only use the original adaptor and the
original cable (supplied).
• Disconnect the Livington Air Cooler
from the power supply for cleaning,
removal/replacement of the filter or
for carrying the unit about.
• Preferably, position the Livington
Air Cooler
®
something like a table or a sideboard.
• Do not position the Livington Air
®
Cooler beside a heater or other
®
electrical appliance.
• Do not place any objects on top of the
Livington Air Cooler
• Do not block the outlets on the front
and rear side of the unit.
• The unit can only be completely
switched off by disconnection from
the power supply.
• A replaceable water filter is designed
specifically for this product. If the
filter is broken or damaged, you
can buy a replacement part. In this
instance, please contact our customer
service department. Contact details
can be found on the last page of this
instruction manual.
USE
A. Remove the water tank and fill it with very cold
water.
B. Put the water tank back into the unit.
C. Connect the USB-Cable to the unit and link the
other cable end with your PC's USB-Port or your
external battery charger. You can also connect the
USB-Cable to a voltage adaptor, which can then
be directly connected to a power supply socket.
D. Switch on the unit by pressing the power switch
on a raised surface,
.
®
®