1. ROUGHING-IN
tub spout
Stops
Hot Inlet
2. VALVE INSTALLATION
Outlet to
Hot Supply
!
CAUTION: If using solder for installation, do not apply excessive heat to the valve body. Applying
excessive heat may result in damage to the seals and plastic components.
Use pipe tape for all connections.
until instruct to remove.
Secure the pipes and valve to the frame.
diagram.
INSTALLATION PROCEDURE
Extra Outlet
(9.2cm)
body spray, etc...)
Plug if not used.
Cold Inlet
Auxilliary Outlet
(Plug if not used)
Outlet to
Finish Wall
Cold Supply
4
MINIMUM/MÍNIMO
FINISH WALL/PARED ACABADA/MUR DE FINITION
MAXIMUM/MÁXIMO