Fracarro SIG7120 Instructions D'emploi page 24

5.1.3 HEADEND SETUP AND EMULATION KTP MENU
Navigation in the
headend programming
menus
HEADEND
SETUP
(not available)
Automatic acknowledgement
of the headend c onnected to
the TPE
Export the headend
configuration to another one
Restore the module
defaults s etting
Not possible
Restart the module
EMULATION
KTP
NOTE: It is possible to modify the address only for the interconnection module SIG7900; after the modify it is
necessary to scan the headend to update the addresses of all module in the rack, otherwise disconnect and
reconnect the TPE from the headend to do the automatic scanning.
SIG7120
SIG7121
Set the input parameters of the
Measurements of the input
NAVIGATION
NAVIGATION OSD
HEADEND
SCANNING
COPY
FACTORY SETUP
ADDRESS SETUP
MODULE RESET
Emulation of the KTP
programmer
EMULATION
KTP
Confirm the settings by pressing the
pressing the S key after the modules programmation.
5.1.4 SIG7120 / SIG7121 GENERAL MENU
Set the output parameters
COFDM (OUTPUT)
TS (INPUT)
Transport Stream
MEASURES
signal
Confirm the settings by pressing the
pressing the S key after the modules programmation.
Refer to the
SIG7120
SIG7120/SIG7121 general
SIG7121
programming menu
Automatic search of the
headend or the c onnected
device. After searching, the
Search module....
main menu can be seen from
the NAVIGATION function
All
SIG7120
Devices
SIG7121
Invalid address
All
SIG7120
Devices
SIG7121
V = EXIT
key; save the settings by
Menù COFDM (Output)
25
see pag.
Menù TS (Input)
26-27
see pag.
Menù MEASURES
29
see pag.
key; save the settings by
4
YES = V NO = X
YES = V NO = X
The function is not
available for the
programming of the
SIG7120 module