DeLorme inReach SE Guide De Démarrage page 4

inReach SE Overview
Status Light
Quit/
Preset Messages
Shortcut
Directional Pad
5
Check the contents of your box.
Your inReach SE includes:
• inReach SE device
Antenna
• Lanyard
• USB cable
Please note: Charge your inReach SE fully before using. Connect the
device to the AC adaptor and plug it into an electrical outlet or use
the USB cable to charge from your computer.
Antenna – Keep the satellite communicator antenna pointing up toward the sky, and the face
of the device pointing away from your body when attached to a pack or a vest.
Status Light – This light flashes green when there is a new message waiting. It flashes red
when there is something important for you to see: low power or a sending message delay.
Micro-USB Port – Lift the protective cover to access the micro-USB port beneath. Use this
port to plug in your USB cable for charging and for updates when notified.
Micro-USB Port
Power/Enter – Press and hold for three seconds to power the inReach SE on. When on, press
to select highlighted objects or hold to access keyboard shortcuts when sending messages.
Directional Pad – Press arrows to highlight a selection on the screen or hold to access
Power/Enter
keyboard shortcuts when sending messages.
Quit/Preset Messages Shortcut – Press to back out of pages or operations. Press and hold
to access the Preset Messages shortcut.
SOS
SOS Button Lock – Slide the SOS button lock to the left to unlock the SOS button in an
emergency.
SOS Button – Press and hold the SOS button for three seconds to send a distress message to
SOS Button Lock
emergency response. If SOS is no longer needed press and hold the SOS button for five seconds
to send a Cancel SOS message to emergency response.
• AC adaptor
• Pack clip
• Quick Start Guide