Velleman CHA008 Mode D'emploi
  1. Manuels
  2. Marques
  3. Velleman Manuels
  4. Électronique automobile
  5. CHA008
  6. Mode d'emploi
Velleman CHA008 Mode D'emploi

Velleman CHA008 Mode D'emploi

Masquer les pouces
1
2
3
4
5
6
7
8
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Liens rapides

Télécharger ce manuel
1. Introduction
At the end of its life cycle, dispose of this product in accordance with local and national disposal
regulations. Read the manual thoroughly before bringing this device into service
Thank you for buying the CHA008! If the device was damaged in transit, don't install or use it and contact your dealer.
Your CHA008 should include: one digital display power capacitor, two mounting brackets, one set of tools and this
manual.
WARNING: This power capacitor may explode and cause serious injury if used or connected improperly. Do not expose
the capacitor to voltages higher than specified in this manual. Do not expose the capacitor to direct sunlight or extreme
temperatures.
2. Specifications
• Digital power capacitor 1fd
• Dimensions: 255mm x Ø78mm
3. Operation
The digital display capacitor is an energy storage device and is designed to supplement power supply during high
current demands to audio amplifiers. An example of such a demand is when the music hits a low bass transient. It is
capable of storing a large amount of energy which can be discharged very fast when needed.
This makes the power capacitor a logical addition to audio systems since automotive batteries are not designed to
deliver the current required in high power car audio installations.
Another feature of the digital display capacitor is that it filters the car's AC voltage induced by the amplifier's power
supply. This can otherwise cause audible noise in the sound system of the car.
4. Installation
1) Install the power capacitor as close to your amplifier as possible for maximum performance. The ideal
location is one that allows short wiring runs while keeping the capacitor somewhat isolated from the heat
created by the amplifier.
2) Keep the positive as short as possible and connect it to the amplifier's battery supply cable. Use a high
performance distribution block to create a splice into this cable.
3) Do not install fuses in the wire between the power capacitor and the amplifier. Instead, make sure that there
is an appropriate fuse at the battery for the main supply cable.
4) Do not ground the capacitor directly to the amplifier ground terminal or ground cable (see fig. below). Keep
the ground cable as short as possible and connect it directly to the vehicle's chassis at a bare metal surface.
Make sure that the positive and the negative wires to the capacitor have the same gauge as the amplifier's
power wires. High performance 8 or 10AWG OFC power cables are a good choice.
CHA008
CHA008 – DIGITAL POWER CAPACITOR
1. Distribution Block
2. In-Line Fuse
3. Power Capacitor
4. Amplifier
5. Battery
1
VELLEMAN

Publicité

Table des Matières
loading

Manuels Connexes pour Velleman CHA008

Sommaire des Matières pour Velleman CHA008

  • Page 1 Read the manual thoroughly before bringing this device into service Thank you for buying the CHA008! If the device was damaged in transit, don't install or use it and contact your dealer. Your CHA008 should include: one digital display power capacitor, two mounting brackets, one set of tools and this manual.

  • Page 2: Specificaties

    If the user accidentally reverses the polarity of (+) and (-), it can cause damage to the system and also be harmful to the user. Therefore, the CHA008 is designed with a PCB relay which, in case of a wrong connection, prevents the unit from turning on and emits a warning buzz.

  • Page 3: Installatie

    Een verkeerde verbinding van (+) en (-) kan schade veroorzaken aan het systeem en kan gevaarlijk zijn voor de gebruiker. De CHA008 is dus ontworpen met een PCB relais die, in geval van een verkeerde verbinding, het systeem afslaat en een waarschuwingsgeluid voortbrengt.

  • Page 4: Spécifications

    Nous vous remercions de votre achat! Si l’appareil a été endommagé pendant le transport, ne l'installez pas et consultez votre revendeur Le CHA008 contient: un capaciteur de puissance numérique, deux supports de montage, un jeu d’accessoires de montage et ce manuel.
  • Page 5 Une connexion inversée du (+) et du (-) peut causer des endommagements au système et peut être dangereux pour l’utilisateur. Le CHA008 a été conçu avec un relais IC qui, en cas d’une connexion inversée, déclenche le système et qui produit un signal d’alarme.

  • Page 6: Función De Seguridad

    Una conexión inversa del (+) y del (-) podría dañar el sistema y lesionar al usuario. El CHA008 ha sido diseñado con un relé CI que desactiva el sistema y produce una señal de alarma en caso de una conexión inversa.

  • Page 7: Technische Daten

    örtlichen und nationalen Gesetzgebung bezüglich Entsorgung. Bitte lesen Sie vor Inbetriebnahme diese Bedienungsanleitung sorgfältig durch. Danke für den Kauf des CHA008! Überprüfen Sie, ob Transportschäden vorliegen. Sollte dies der Fall sein, verwenden Sie das Gerät nicht und wenden Sie sich an Ihren Händler. Der Lieferumfang enthält 1 Power-Kondensator mit Digitalanzeige, 2 Montagebügel, 1 Werkzeugsatz und diese Bedienungsanleitung.
  • Page 8 4) Wenn die Gleichspannung des Wagens ±0.1 Ampere überschreitet, wird der digitale Power-Kondensator automatisch funktionieren. 5) Wenn die Gleichspannung des Wagens 0.1 Ampere nicht überschreitet, dann wird der CHA008 eine Minute im "ON" Status bleiben, um die Stabilität des elektronischen Systems zu gewährleisten. Der CHA008 wird automatisch ausschalten und im 'Stand-By'-Modus schalten.

Table des Matières