Mounting And Changing Attachments - Bamix Basic M120 Mode D'emploi

Recess
Drive pin
Mount and remove attachment
vertically
20

Mounting and changing attachments

All attachments feature a recess (figure 1).
The drive shaft stub of the bamix
(figure 2).
Push the attachment as straight as possible onto the stub so
that the drive pin engages in the recess on the attachment.
Please make sure that the attachment is exactly parallel to the
cutter guard and properly aligned with the stub (figures 3/4).
To remove the attachment, just pull it from the stub.
If the attachment cannot be easily pulled off, loosen it by placing the
bamix in hot soapy water and switching the appliance on briefly.
®
Disconnect the power plug from the socket and pull off the attachment.
If necessary, lever it off with a suitable implement (e.g. screwdriver).
Before changing the attachment, disconnect the
power plug of the appliance from the power plug.
Do not touch rotating attachments.
is equipped with a drive pin
®