Volpi PV295 Mode D'emploi page 38

14.2. Opening change
The PV295 pruner is equipped with a blade opening change system with memory.
It means that it is possible to adjust the opening of the blade according to the desired
cutting diameter.
The opening of the blades can be adjusted in two positions :
- 100% blades opening
- Approx 70% blades opening
Procedure to adjust the opening of the blade :
• Press the power button. After the sound signal, press the trigger twice in rapid sequence
to open the blades - 100% blades opening.
• Press the power button. After the sound signal, press the trigger and after the other
sound sigal, release the trigger - approx 70% blades opening.
• Press the power button. After the sound signal, press the trigger and after the other
sound sigal, release the trigger - 100% blades opening.
Caution: please check battery charge level or blade sharpening when cutting is difficult or not
smooth.
15. Maintenance and cleaning
Tools to be repaired must be sent to Customer Assistance Service. Use original part keeps the
tool good condition and safe.
Disconnect the battery from the tool before checking, maintaining and repairing the pruning
shear, to avoid risk of unexpected activation of the tool.
Warning!
In particular situations of very hard use, the blade and the handle could reach high temperatures. It is
recommended to handle the pruner with care, using protective gloves.
Please wear glove before you check the blade is sharp or not, that is to avoid blade hurt you.
Check the pruning shear frequently, this will keep tool safe and reliable.
38