ensto Smartcloser NX2008287 Manuel D'installation page 51

English
General
- Before unpacking
> Verify that the product in its packaging has not been damaged during transport.
> Verify that the product is suitable for the intended installation.
- Before installation
> Carefully read the operation guide before installing or using this product.
> Perform the installation carefully, ensuring that the equipment remains clean throughout the operation.
- After installation
> If you are installing this product for someone else, leave the guide for the end user.
> Clean the work area after installation.
Legal notices
The product may only be installed by a competent person with adequate training in the installation practices and
with adequate knowledge of proper safety and installation practices for electrical equipment. If local regulations
have requirements relating to this training or adequate knowledge in terms of the installation of electrical
equipment, the aforementioned requirements must be complied with by this person.
Ensto Novexia will not be held responsible in any way for damage to property or persons caused by an incorrect
installation, incorrect operation or lack of compliance with the safety instructions.
WARNING :
For the operation of this system in complete safety, it is essential that the installers, users and
technicians follow the procedures and precautions described in this guide. Non-compliance
with these instructions may cause damage to the products and/or serious or even mortal
injury.
SMARTCLOSER - N°IFS NX2008287 / N° 72740_08
01.10.2020
51 (101)