Audio Setup - ION Audio RECORD 2 PC Guide D'utilisation Simplifié

RECORD 2 PC QUICKSTART GUIDE
CONNECTING THE RECORD 2 PC
The ION Audio RECORD 2 PC is a plug-and-play device, which means that there are
no drivers to install. The first time you connect it to your computer, it will
automatically install all the necessary driver components and be ready to use.
IMPROVING AUDIO QUALITY
If you are experiencing unexpected noise, hiss or distortion in your recordings, here are a few things you can do to improve
the quality of your sound as you use RECORD 2 PC:
•
Use higher-quality RCA cables when connecting your sound source to RECORD 2 PC.
•
Connect RECORD 2 PC to a different USB port on your computer. (USB ports on the rear panel typically work best.)
•
Close all software applications other than your recording application (e.g., EZ Vinyl/Tape Converter).
•
If you are using a laptop, disconnect your laptop's power supply.
•
Experiment with connecting your computer and/or sound source to different power outlets (or the same power outlet).
•
Experiment with repositioning RECORD 2 PC and other audio cables away from possible noise sources (e.g.,
computers, power cables, speakers, amps, etc.)
•
Ensure the connections between all your devices are secure (including the grounding wire of your record player, if it
has one).
•
Visit www.ionaudio.com/computer-optimization for more information on optimizing your computer for audio.

AUDIO SETUP

In most cases (especially if you are using Windows) RECORD 2
PC will be automatically selected as your computer's default
recording device. If you find you are unable to record any audio
with RECORD 2 PC, follow the instructions below for your
operating system.
Also, be sure your audio software program is set up to receive
audio via RECORD 2 PC.
software's "Preferences" or "Device Setup." Please consult your
software manual for more information.
WINDOWS XP
1. Go to Start Menu
and Audio Devices.
2. Click the "Audio" tab.
3. Under "Sound Recording," make sure USB
Audio CODEC is selected as the default device,
then click "OK."
WINDOWS VISTA
1. Go to Start Menu
(If you don't see Sound, select "Switch to Classic
View," and the Sound Control Panel should
become available.)
2. Select the "Recording" tab.
3. Make sure Microphone – USB Audio CODEC is
set as the default device, then click "OK."
This can usually be done in your
Control Panel Sounds
Control Panel Sound.
IMPORTANT:
• Adjust the volume dial (on the side of
RECORD 2 PC) to prevent distortion at loud
volumes.
• When using RECORD 2 PC with turntables,
set its switch to "PHONO." When using it with
3
SYSTEM REQUIREMENTS:
PC: Windows XP, Vista or 7
Mac: OS X or higher
USB Port