Functions And Features; Time Setting - König Electronic KN-CL30 Mode D'emploi

Wall Clock
First insert 2 "AA" batteries into the battery compartment after opening the battery door of the wall clock
and insert 1 "AA" battery into the compartment, then insert 2 "AAA" batteries into the sensor (transmitter)
after opening the battery door with a screw driver.

Functions and features:

- Indoor temperature display
- RF outdoor temperature display
- Weather forecast display
- RF receiving channels: CH1, CH2, CH3
- Temperature format: (°C/°F)
- Outdoor temperature range: - 20°C~50°C, Accuracy: +/-1°C

Time setting

- After putting 1 AA battery into the compartment, adjust the back wheel to set the time.
RF outdoor temperature instruction
Normal mode keys functions:
- Press the "°C/°F/DOWN" key to switch between °C/°F. The default temperature format is: °C.
- Press the "C/H/UP" key to switch between CH1, CH2 and CH3.
RF receiving
- After inserting the batteries in the clock and outdoor sensor, it will automatically enter RF mode
receiving for 3 minutes. The icon of the antenna will start to flash with 1 Hz frequency.
- In normal mode, hold the "UP" key for 2 seconds to clear the display data of the current RF channels
and renew the data again.
- If no signals are received within 60 minutes, the CH temperature will show "--.-", and it will enter an
RF long receiving mode for 3 minutes.
- If it receives effective signals within 3 minutes, it will exit the RF long receiving mode and enter the
normal mode.
- If a signal is still not received within 3 minutes, it will exit RF receiving mode and enter the RF long
receiving mode within an hour. This will repeat every hour till it receives a signal.
- During RF receiving, the antenna icon starts to flash with 2 Hz frequency, and it will keep the icon on
screen if it receives the temperature signal. If no temperature is received, the icon will disappear.
Weather forecast functions:
- Weather forecast functions can forecast the weather conditions of the next 24 hours.
- Weather grade: Sunny/Slightly Cloudy/Cloudy/Rainy.
- Time of sensing: 30 minutes.
Wireless remote sensor (transmitter) instruction
- Transmitter frequency: 433.92 MHz.
- Batteries: 2x 1.5 V AAA.
- Use a screwdriver to remove the back of the battery compartment cover, insert the batteries into the
transmitter according to the correct polarity.
- Press the "°C/°F" button to select the temperature, either in °C or °F.
- You can put the transmitter in a garage, on an outdoor wall or window, indoor living room or garden.
- The maximum distance for the transmitter and receiver is up to 30 m (100 feet) in an open area.
ENGLISH
2