Multi-Stage Cooking - BORETTI M-SYSTEM MCM-400 Notice D'emploi

1) Press the "CONVECTION " key once, "140" flash.
2) Keep pressing "CONVECTION" or turn "
Note:the temperature can be chosen from 140 degrees to 230 degrees.
3) Press the " START/+30SEC./CONFIRM " to confirm the temperature.
4) Press the " START/+30SEC./CONFIRM " to start preheating.When the
preheating temperature arrives, the buzzer will sound twice to remind you to
put the food into the oven. And the preheated temperature is displayed and flash.
5) Put the food into the oven and close the door.
Turn " " to adjust the cooking time. (The maximum setting time is 95 minutes.)
6) Press the " START/+30SEC./CONFIRM " key to start cooking.
Note: a. Cooking time cannot be input until the preheating temperature arrives.
If the temperature arrives, door must be opened to input the cooking time.
b. If the time not input in 5 minutes, the oven will stop preheating. The buzzer sound
five times and turn back to waiting states.
6. Convection Cooking( Without pre-heating function)
1) Press the "CONVECTION " key once, "140" flash.
2) Keep pressing "CONVECTION" or turn "
Note:the temperature can be chosen from 140 degrees to 230 degrees.
3) Press the " START/+30SEC./CONFIRM " to confirm the temperature
4) Turn " " to adjust the cooking time. (The maximum setting time is 95 minutes.)
5) Press the " START/+30SEC./CONFIRM " key to start cooking.

7.Multi-Stage Cooking

Three stages can be maximumly set. If one stages is defrosting, it should be put in the first
stage. The buzzer will ring once after each stage and the next stage will begin.
Note: Auto menu and preheating cannot be set as one of the multi-stage.
Example: if you want to defrost the food for 5 minutes, then to cook with 80%
microwave power for 7 minutes. The steps are as following:
1) Press "W.T./TIME DEFROST " twice, the screen will display "dEF2";
2) Turn " " to adjust the defrost time of 5 minutes;
3) Press"MICROWAVE" once;
4) Press " MICROWAVE" for times or turn "
" to select the convection function.
" to select the convection function.
" till "P80" display;
EN-11