Télécharger Imprimer la page

Publicité

Liens rapides

MAA-706
Audiophile power mono amplifier
Amplificateur de puissance audiophile mono

Publicité

loading

Sommaire des Matières pour Advance acoustic MAA-706

  • Page 1 MAA-706 Audiophile power mono amplifier Amplificateur de puissance audiophile mono...
  • Page 2 RECYCLING IN EUROPEAN UNION COUNTRIES Disposal of your old appliance Swedish English Märkningen av produkter och fôrpackningar med denna This symbol on the product or on its packaging means that symbol betyder att elektrisk och elektronisk utrustning your electrical and electronic equipment should be disposed maste tasom hand séparât fràn hushàlissopor nàr utrus- at the end of life separately from your household wastes.
  • Page 3 WARNING ATTENTION ATTENTION: afin de réduire tout risques de chocs électri- ques ou de feu, ne pas exposer votre appareil à l’humidité ou à toutes sortes de liquides WARNING: to reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.
  • Page 4 CONSIGNES DE SECURITE LIRE LES INSTRUCTIONS PROTECTION DU CORDON SECTEUR Votre cordon d’alimentation doit être correc- Toutes les consignes de sécurité et instruc- tions quand à l’utilisation de notre produit doi- tement installée afin qu’il ne soit pas piétiner vent faire l’objet d’une lecture attentive. ou arracher.
  • Page 5 SAFETY INSTRUCTIONS READ INSTRUCTIONS POWER-CORD PROTECTION Power-supply cords should be routed so All the safety and operating instructions should be read before the appliance is that they are not likely to be walked on operated. or pinched by paying particular attention to cords at plugs, convenience RETAIN INSTRUCTIONS receptacles, and the point where they exit...
  • Page 6 RÉGLAGES FACE AVANT FRONT PANEL CONTROLS BOUTON STANDBY/ON Appuyez sur ce bouton pour mettre en marche votre appareil (éclairage bleu de votre bouton après sa temporisation). La mise en marche de votre appareil ne peut se faire que si le bouton Marche/Arrêt général situé sur la face arrière est en position ON. En mode STANDBY, l’alimentation principale est coupée à...
  • Page 7 METERS They displays on left and right channels the peak power level into an 8 ohms load. Also, they integrate the signal over a short enough time to give an accurate representation of the average power. VOYANTS DE PROTECTION Quand votre amplificateur de puissance est mis en marche, le circuit de protection (tem- porisation) isolent les enceintes pendant quelques secondes afin d’empêcher les surchar- ges électriques d’atteindre les haut-parleurs.
  • Page 8 RÉGLAGES & CONNEXIONS FACE ARRIÈRE REAR PANEL CONNECTIONS & CONTROLS PRISE D’ALIMENTATION /INTERRUPTEUR GÉNÉRAL / SÉLECTEUR DE TENSION Pour alimenter votre appareil, commuter l’interrupteur général sur ON et vérifier la tension d’alimentation. Si votre tension est de 115V vous devez changer les fusibles avec ceux fournis.
  • Page 9 BALANCED AUDIO INPUTS (BAL. R et BAL. L) If your preamplifier has balanced outputs, you have the possibility to connect it on the balanced inputs of your power amplifier MAA-406. ENTREES ASYMETRIQUES GAUCHE (CH.L) ET DROITE (CH.R)/AUDIO INPUTS Ces connecteurs vous permettent de relier en mode asymétrique les entrées gauche CH.L) et droite (CH.R) de votre amplificateur de puissance MAA-406 aux sorties asymé- triques gauche (L) et droite (R) de votre préamplificateur.
  • Page 10 WARNING ATTENTION Good No good Your product is designed to be placed on a firm and level surface. Don’t place the unit sideways, a big power exerts on the single side of the plate. With this power, the plate will be broken easily. Please see the picture. Votre produit a été...
  • Page 11 SPECIFICATIONS ET PERFORMANCES PERFORMANCE SPECIFICATIONS POWER OUTPUT 8Ω 200W POWER OUTPUT 4Ω 300W FREQUENCY RESPONSE (-3dB) 10Hz-50kHz DISTORSION < 0,05% S/N RATIO ≥ 120 dB INPUT IMPEDANCE 20KΩ AC INPUT 115-230V POWER CONSUMPTION S/BY < 1W POWER CONSUMPTION MAX < 500W TRANSFORMER(S) 1 (700VA) DIMENSIONS...
  • Page 12 Design and development in France by Advance Paris Sarl 13 rue du coq gaulois - 77390 Brie Comte Robert - FRANCE Tel. +33 (0) 160 185 900 - Fax +33 (0) 160 185 895 email: info@advance-acoustic.com www.advance-acoustic.com...